Cisco Systems IPS4510K9 Installing the IPS 4510 and IPS, 1G SFP Module, 10G SFP+ Module, 7-12

Chapter 7 Installing the IPS 4510 and IPS 4520

Installing the IPS 4510 and IPS 4520

Table 7-7lists the SFP/SFP+ modules that the IPS 4510 and IPS 4520 support.

Table 7-7 SFP/SFP+ Modules

1G SFP Module

GLC-SX-MM	1000 Base-SX SFP module
GLC-SX-MMD	1000BASE-SX short wavelength, with DOM
GLC-LH-SM	1000 Base-LX/LH SFP module
GLC-LH-SMD	1000BASE-LX/LH long-wavelength, with DOM
GLC-T	1000BASE-T standard
10G SFP+ Module
SFP-10G-ER	10G	ER SFP+ module
SFP-10G-SR	10G	SR SFP+ module
SFP-10G-LRM	10G	LRM SFP+ module
SFP-10G-LR	10G	LR SFP+ module
SFP-H10GB-ACU7M	10GBASE-CU SFP+ Cable 7 Meter, active
SFP-H10GB-ACU10M	10GBASE-CU SFP+ Cable 10 Meter, active
SFP-H10GB-CU1M	10GBASE-CU SFP+ cable 1 meter, passive
SFP-H10GB-CU3M	10GBASE-CU SFP+ cable 3 meter, passive
SFP-H10GB-CU5M	10GBASE-CU SFP+ cable 5 meter, passive

Installing the IPS 4510 and IPS 4520

The IPS 4510 and IPS 4520 have two dedicated Gigabit Ethernet interfaces for device management that are called Management 0/0 and Management 0/1. The additional interface, Management 0/1 is reserved for future use. The management interfaces are similar to the console port, because they only accept traffic that is destined to-the-box (versus traffic that is through-the-box).

To connect the IPS 4510 and IPS 4520 cables to the network interfaces, follow these steps:

Step 1 Place the sensor on a flat, stable surface, or in a rack (if you are rack-mounting it).

Step 2 Connect to the management interface, Management 0/0.

a.Locate an Ethernet cable, which has an RJ-45 connector on each end.

	Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
7-12	OL-24002-01