![](/images/new-backgrounds/1158890/15889039x1.webp)
Chapter 2 Overview: Cisco 7600 Series Ethernet Services Plus Line Cards
Identifying Slots and Subslots for the Cisco 7600 Cisco 7600 Series ES+ Line Cards
Note The Cisco 7600 Series ES+ line cards are not supported with a Supervisor Engine 1, Supervisor Engine 1A, Supervisor Engine 2, Supervisor Engine
For information about the chassis slots available in different Cisco 7600 series router models, see http://www.cisco.com/univercd/cc/td/doc/product/core/cis7600/hardware/cis_76xx/osr_over.htm.
Some commands allow you to display information about the Cisco 7600 Series ES+ line card itself, such as show module, show idprom module, show
For example, to display status and information about the Cisco 7600 Series ES+ line card installed in slot 10 of a Cisco 7609 router, enter the following command:
Router# show module 10
Mod | Ports | Card Type |
|
| Model | Serial No. | ||
10 | 20 | 7600 ES+ |
|
| JAE1151865I | |||
Mod | MAC addresses |
| Hw | Fw | Sw |
| Status | |
10 | 001d.e5e8.2a00 to 001d.e5e8.2a3f | 0.301 12.2(33r)SRD 12.2(nightly | Ok | |||||
Mod | Model |
|
| Serial | Hw | Status | ||
10 | 7600 | ES+ DFC XL |
| JAE115188YM | 0.200 | Ok | ||
10 | 7600 | ES+ 20xGE SFP |
| JAE1151860R | 0.301 | Ok |
Mod Online Diag Status
----
10 Pass
Router#
For more information about Cisco 7600 Series ES+ line card commands, see the Cisco IOS Software Releases 12.2 SR Command References.
Note The Cisco 7600 Series ES+ line card must be in a slot that provides two primary serial channels. Dual serial channels are not available in all slots of a
Cisco 7600 ES+ Line Card Slot, Bay, and Port Locations
The Cisco 7600 Series ES+ line card uses a <slot, port> numbering scheme. The slot refers to whichever slot the line card occupies in the router. The port numbering begins at 1 on all versions of the Cisco 7600 Series ES+ line card. The upper limit depends on the card type. This physical port numbering is reflected in CLI messages and all references to port numbers that are visible to the user.
Executing the show interface command for a Cisco 7600 Series ES+ line card located in slot 10 of a Cisco 7600 series router chassis produces the following (only first six interfaces are shown):
Router# show interfaces gigabitEthernet 10/2
|
|
| GigabitEthernet10/2 is | up, line protocol is up (connected) | |
|
|
| Hardware is X40G 1Gb | 802.3, address is 000f.35c2.ec00 (bia 000f.35c2.ec00) | |
|
|
| Description: connect | to test 7/2 | |
|
|
| MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, | ||
|
|
| Cisco 7600 Series Ethernet Services Plus Line Card Hardware Installation Guide | ||
|
|
| |||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|