Cisco Systems OL-4387-02 Prerequisites for SSG Unconfig, Configuration of SSG Unconfig, 11-6

Chapter 11 Miscellaneous SSG Features

SSG Unconfig

Prerequisites for SSG Unconfig

You must enable SSG before you configure SSG Unconfig.

Configuration of SSG Unconfig

To configure SSG Unconfig, perform any of the following optional tasks:

•Unconfigure SSG and release system resources by entering the no ssg enable force-cleanupcommand in global configuration mode.

•Remove one or more SSG host objects by entering the clear ssg host command in privileged EXEC configuration mode.

•Remove one or more SSG service objects by entering the clear ssg service command in privileged EXEC configuration mode.

For more information, refer to the SSG Unconfig, Release 12.2(15)B feature module.

Configuration Examples for SSG Unconfig

Example 11-1shows how to unconfigure SSG and release system resources.

Example 11-1 Unconfiguring SSG and Releasing System Resources

Router(config)# no ssg enable force-cleanup

04:35:02: Delete all active host objects. It may take some time, please wait.

04:35:-02: ssg_unconfig_proc: UNCONFIGURATION COMPLETE

Example 11-2shows how to remove all host objects associated with a downlink interface and then verify that all host objects on that interface are removed.

Example 11-2 Removing Host Objects on an Interface

Router# clear ssg host range 0.0.0.0 255.255.255.255 FastEthernet0/1

Router# show ssg host FastEthernet0/1

##Total HostObject Count:0

For more configuration examples, refer to the SSG Unconfig, Release 12.2(15)B feature module.

Cisco 10000 Series Router Service Selection Gateway Configuration Guide

11-6 OL-4387-02