Cisco Systems OL-4387-02 Miscellaneous SSG Features, VPI/VCI Static Binding to a Service Profile

C H A P T E R 11

Miscellaneous SSG Features

This chapter describes the following SSG features:

•VPI/VCI Static Binding to a Service Profile, page 11-1

•RADIUS Virtual Circuit Logging, page 11-2

•AAA Server Group Support for Proxy Services, page 11-2

•Packet Filtering, page 11-3

•SSG Unconfig, page 11-5

•SSG Enhancements for Overlapping Services, page 11-7

VPI/VCI Static Binding to a Service Profile

The VPI/VCI Static Binding to a Service Profile feature allows users accessing SSG through a VPI/VCI or a range of VPI/VCIs to access the server. When a user session arrives on a VPI/VCI or a VPI/VCI range and the session specifies the username but does not specify the domain name, SSG maps the user session to the service to which the VPI/VCI or VPI/VCI range is bound.

For more information, refer to the”Configuring VPI/VCI Indexing to Service Profile” section in the Node Route Processor—Service Selection Gateway Enhancements, Release 12.0(5)DC feature module.

Restrictions for VPI/VCI Static Binding to a Service Profile

The VPI/VCI Static Binding to a Service Profile feature has the following restrictions:

•The feature applies only to PPP sessions.

•You must statically configure the feature.

•SESM cannot map the VC to the service.

Configuration of VPI/VCI Static Binding to a Service Profile

To map a VC to a service, use the ssg vc-service-mapcommand in global configuration mode. For more information, refer to the ”Broadband Access: Service Selection Gateway Commands” section in the Cisco IOS Wide-Area Networking Command Reference, Release 12.2T.

Cisco 10000 Series Router Service Selection Gateway Configuration Guide

OL-4387-02 11-1