Cisco Systems OL-6426-02 manual Configure Bridging on VLANs, Station-role repeater root

Chapter 9 Configuring a Wireless LAN Connection

Configure Bridging on VLANs

BETA DRAFT - CISCO CONFIDENTIAL

	Command	Purpose
Step 12
	station-role [repeater root]	(Optional) Specifies the role of this wireless
		interface.
	Example:	You must specify at least one root interface.
	Router(config-if)# station-role root
	Router(config-if)#
Step 13
	exit	Exits interface configuration mode, and enters
		global configuration mode.
	Example:
	Router(config-if)# exit
	Router(config)#

Configure Bridging on VLANs

Perform these steps to configure integrated routing and bridging on VLANs, beginning in global configuration mode:

	Command or Action	Purpose
Step 1
	bridge [number crb irb mac-address-table]	Specifies the type of bridging.
	Example:	The example specifies integrated routing and
		bridging.
	Router(config)# bridge irb
	Router(config)#
Step 2
	interface name number	Enters interface configuration mode.
	Example:	We want to set up bridging on the VLANs, so the
		example enters the VLAN interface
	Router(config)# interface vlan 1	configuration mode.
	Router(config)#
Step 3
	bridge-group number	Assigns a bridge group to the interface.
	Example:
	Router(config)# bridge-group 1
	Router(config)#
Step 4
	bridge-group parameter	Sets other bridge parameters for the bridging
		interface.
	Example:
	Router(config)# bridge-group
	spanning-disabled
	Router(config)#

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

OL-6426-02 9-5