Chapter 4 Configuring PPP over ATM with NAT

Configure DSL Signaling Protocol

BETA DRAFT - CISCO CONFIDENTIAL

 

Command

Purpose

 

Step 5

 

 

 

line-mode {4-wire enhanced 4-wire standard

Specifies whether this DSL connection is

 

 

2-wire}

operating in 2-wire, 4-wire standard, or 4-wire

 

 

 

enhanced mode.

 

 

Example:

 

 

 

 

 

 

Router(config-controller)# line-mode4-wire

 

 

 

 

 

 

Note

line mode 4-wirewill default to 4-wire

 

 

standard

 

 

Router(config-controller)#

 

 

 

enhanced mode.

 

Step 6

 

 

 

 

 

 

 

ignore-error-duration number

Specifies how long, 15 to 30 seconds, to ignore

 

 

 

errors.

 

 

 

Example:

 

 

 

 

 

 

Router(config-controller)#

 

 

 

 

 

 

ignore-error-duration 15

 

 

 

 

 

 

Router(config-controller)#

 

 

 

 

 

Step 7

 

 

 

exit

Exits controller configuration mode, returning to

 

 

 

global configuration mode.

 

 

Example:

 

 

 

 

 

 

Router(config-controller)# exit

 

 

 

 

 

 

Router(config)#

 

 

 

 

 

 

 

 

 

 

 

 

Note If you are integrating your Cisco router into a European network, please use one of the following commands:

For CO mode, use the dsl dsl-mode shdsl symmetric annex {A B B-ANFP} command to choose annex B or B-ANFP.

For CPE mode, use the dsl dsl-mode shdsl symmetric annex {A A-B A-B-ANFP B B-ANFP} to choose any option except option A.

The router uses annex A by default (United States).

Verify the Configuration

 

 

 

You can verify that the configuration is set the way you want using the show controllers dsl command

 

 

 

from privileged EXEC mode.

 

 

 

Router# show controllers dsl 0

 

 

 

DSL 0 controller UP

 

 

 

SLOT 0: Globespan xDSL controller chipset

 

 

 

Line Mode: Four Wire Standard Mode

 

 

 

DSL mode: SHDSL Annex A

 

 

 

Frame mode: Utopia

 

 

 

Configured Line rate: Auto

 

 

 

Line Re-activated 6 times after system bootup

 

 

 

LOSW Defect alarm: ACTIVE

 

 

 

CRC per second alarm: ACTIVE

 

 

 

Line termination: CPE

 

 

 

Current 15 min CRC: 0

 

 

 

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

 

 

 

 

 

 

 

 

 

4-8

 

OL-6426-02

 

 

 

 

Page 58
Image 58
Cisco Systems OL-6426-02 manual Line-mode 4-wire enhanced 4-wire standard, Wire, Ignore-error-duration number