Cisco Systems OL-6426-02 manual Configuring Shdsl, Verify the Configuration

Chapter 4 Configuring PPP over ATM with NAT

Configure DSL Signaling Protocol

BETA DRAFT - CISCO CONFIDENTIAL

If you wish to change any of these settings, use one of the following commands in global configuration mode.

•dsl operating-mode(from the ATM interface configuration mode)

•dsl lom integer

•dsl enable-training-log

See the Cisco IOS Wide-Area Networking Command Reference for details of these commands.

Verify the Configuration

You can verify that the configuration is set the way you want using the show dsl interface atm 0 command from privileged EXEC mode.

Configuring SHDSL

Complete the following steps to configure the DSL controller in your router to use SHDSL signaling, beginning in global configuration mode.

	Command	Purpose
Step 1
	controller dsl port	Enters the configuration mode for the DSL
		controller.
	Example:
	Router(config)# controller dsl 0
	Router(config-controller)#
Step 2
	line-term {co cpe}	Specifies if the DSL line is terminated at a central
		office (CO) or at customer premises equipment
	Example:	(CPE).
	Router(config-controller)# line-term co
	Router(config-controller)#
Step 3
	exit	Exits controller configuration mode, returning to
		global configuration mode.
	Example:
	Router(config-controller)# exit
	Router(config)#
Step 4
	mode protocol	Specifies the mode of the DSL controller and
		enters controller configuration mode.
	Example:
	Router(config)# mode atm
	Router(config-controller)#

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

OL-6426-02 4-7