Cisco Systems OL-6426-02 manual Configure Network Address Translation

Chapter 4 Configuring PPP over ATM with NAT

Configure Network Address Translation

BETA DRAFT - CISCO CONFIDENTIAL

Current 15 min LOSW Defect: 0

Current 15 min ES Defect: 0

Current 15 min SES Defect: 0

Current 15 min UAS Defect: 33287

Previous 15 min CRC Defect: 0

Previous 15 min LOSW Defect: 0

Previous 15 min ES Defect: 0

Previous 15 min SES Defect: 0

Previous 15 min UAS Defect: 0

Line-0 status

Chipset Version: 0

Firmware Version: A388

Modem Status: Data, Status 1

Last Fail Mode: No Failure status:0x0

Line rate: 2312 Kbps

Framer Sync Status: In Sync

Rcv Clock Status: In the Range

Loop Attenuation: 341.1450 dB

Transmit Power: 7.5 dB

Receiver Gain: 22.5420 dB

SNR Sampling: 36.8590 dB

Dying Gasp: Present

Configure Network Address Translation

Network Address Translation (NAT) translates packets from addresses that match a standard access list, using global addresses allocated by the dialer interface. Packets that enter the router through the inside interface, packets sourced from the router, or both are checked against the access list for possible address translation. You can configure NAT for either static or dynamic address translations.

Perform these steps to configure the outside ATM WAN interface with dynamic NAT, beginning in global configuration mode:

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

OL-6426-02 4-9