Cisco Systems OL-6426-02 manual Command Reference, Volume 1 of 4 Routing

Chapter 4 Configuring PPP over ATM with NAT

Configure the Dialer Interface

BETA DRAFT - CISCO CONFIDENTIAL

	Command	Purpose
Step 7
	dialer-group group-number	Assigns the dialer interface to a dialer group
		(1–10).
	Example:	Tip	Using a dialer group controls access to
	Router(config-if)# dialer-group 1		your router.
	Router(config-if)#
Step 8
	exit	Exits the dialer 0 interface configuration.
	Example:
	Router(config-if)# exit
	Router(config)#
Step 9
	dialer-listdialer-group protocol protocol-name	Creates a dialer list and associates a dial group
	{permit deny list access-list-number	with it. Packets are then forwarded through the
	access-group}	specified interface dialer group.
	Example:	For details about this command and additional
		parameters that can be set, see the Cisco IOS Dial
	Router(config)# dialer-list 1 protocol ip	Technologies Command Reference.
	permit
	Router(config)#
Step 10
	ip route prefix mask {interface-type	Sets the IP route for the default gateway for the
	interface-number}	dialer 0 interface.
	Example:	For details about this command and additional
		parameters that can be set, see the Cisco IOS IP
	Router(config)# ip route 10.10.25.0	Command Reference, Volume 1 of 4: Routing
	255.255.255.0 dialer 0	Protocols.
	Router(config)#

Repeat these steps for any additional dialer interfaces or dialer pools needed.

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

4-4 OL-6426-02