Cisco Systems OL-6426-02 manual Configuring Dialer Watch, 13-4

Chapter 13 Configuring Dial Backup and Remote Management

Dial Backup Feature Activation Methods

Dialer Watch

The dialer watch method only supports the Extended Interior Gateway Routing Protocol (EIGRP) link-state dynamic routing protocols.

Configuring Dialer Watch

Perform these steps to configure a dialer watch on your router, beginning in global configuration mode:

	Command	Purpose
Step 1
	interface type number	Enters configuration mode for the dial backup
		interface.
	Example:
	Router(config)# interface dialer 2
	Router(config-if)#
Step 2
	dialerwatch-group group-number	Specifies the group number for the watch list.
	Example:
	Router(config-if)#dialer watch-group 2
	Router(config-if)#
Step 3
	exit	Enters global configuration mode.
	Example:
	Router(config-if)# exit
	Router(config)#
Step 4
	ip route prefix mask {ip-address interface-type	Assigns the primary route. 22.0.0.2 is the peer IP
	interface-number [ip-address]} [distance]	address of the primary interface.
	Example:
	Router(config)# ip route 0.0.0.0 0.0.0.0
	22.0.0.2
	Router(config)#

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

13-4 OL-6426-02