Cisco Systems OL-6426-02 manual Output Cause, Shutdown command, 14-4

Chapter 14 Troubleshooting

ATM Troubleshooting Commands

BETA DRAFT - CISCO CONFIDENTIAL

Hardware is PQUICC_SAR (with Alcatel ADSL Module) Internet address is 14.0.0.16/8

MTU 1500 bytes, sub MTU 1500, BW 640 Kbit, DLY 80 usec, reliability 40/255, txload 1/255, rxload 1/255

Encapsulation ATM, loopback not set Keepalive not supported Encapsulation(s):AAL5, PVC mode

10 maximum active VCs, 1 current VCCs VC idle disconnect time:300 seconds

Last input 01:16:31, output 01:16:31, output hang never Last clearing of "show interface" counters never

Input queue:0/75/0 (size/max/drops); Total output drops:0 Queueing strategy:Per VC Queueing

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

512 packets input, 59780 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 1024 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 426 packets output, 46282 bytes, 0 underruns

0 output errors, 0 collisions, 2 interface resets

0 output buffer failures, 0 output buffers swapped out

Router# show interface fastethernet 0 Ethernet0 is up, line protocol is up

Hardware is PQUICC Ethernet, address is 0000.Oc13.a4db (bia0010.9181.1281)

Internet address is 170.1.4.101/24

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 255/255., txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec)

Router# show interface dialer 1 Dialer 1 is up, line protocol is up

Hardware is Dialer interface Internet address is 1.1.1.1/24

MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec, reliability 255/255. txload 1/255, rxload 1/255

Encapsulation PPP, loopback not set Keepalive set (10 sec)

DTR is pulsed for 5 seconds on reset LCP Closed

Table 14-1describes possible command output for the show interface command.

Table 14-1 show interface Command Output Description

Output

Cause

For ATM Interfaces

ATM 0 is up, line protocol is up	The ATM line is up and operating correctly.
ATM 0 is down, line protocol is down	• The ATM interface has been disabled with the
	shutdown command
	or
	• The ATM line is down, possibly because the
	ADSL cable is disconnected or because the
	wrong type of cable is connected to the ATM
	port.

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

14-4 OL-6426-02