Cisco Systems OL-6426-02 manual Line Configuration, 13-15

Chapter 13 Configuring Dial Backup and Remote Management

Configuring Dial Backup and Remote Management Through a V.92 Modem

Line Configuration

Perform these steps to configure the line on the V.92 modem, beginning in global configuration mode:

	Command	Purpose
Step 1
	line line-number	Identifies a specific line for configuration and
		enters line configuration collection mode.
	Example:	Note The number entered here must be the same
	Router(config)# line 1	as the number entered for the
	Router(config-line)	asynchronous serial interface.
Step 2	modem inout	Configures the line for both incoming and
		outgoing calls.
	Example:
	Router(config-line)# modem inout
	Router(config-line)#
Step 3	autoselect {arap ppp slip during-login	Configures the line to automatically start an
	timeout seconds}	AppleTalk Remote Access (ARA), PPP, or SLIP
		session.
	Example:	Note We recommend ppp for use with the dial
	Router(config-line)# autoselect ppp	backup feature.
	Router(config-line)#
Step 4	transport input {all lat mop nasi none	Defines which protocols can be used to connect to
	pad rlogin telnet v120}	the line.
	Example:	Note We recommend all for use with the dial
		backup feature.
	Router(config-line)# transport input all
	Router(config-line)#
Step 5
	exit	Exits line configuration mode, and enters global
		configuration mode.
	Example:
	Router(config-line)# exit
	Router(config)#

	Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
OL-6426-02		13-15