Cisco Systems OL-6426-02 manual 13-10

Chapter 13 Configuring Dial Backup and Remote Management

Configuring Dial Backup and Remote Management Through the ISDN S/T Port

Perform these steps to configure your router ISDN interface for use as a backup interface, beginning in global configuration mode:

	Command	Purpose
Step 1
	isdn switch-type switch-type	Specifies the ISDN switch type.
	Example:	The example specifies a switch type used in
		Australia, Europe, and the United Kingdom. For
	Router(config)# isdn switch-type basic-net3	details on other switch types supported, see the
	Router(config)#	Cisco IOS Dial Technologies Command
		Reference.
Step 2
	interface type number	Enters configuration mode for the ISDN Basic
		Rate Interface (BRI).
	Example:
	Router(config)# interface bri 0
	Router(config-if)#
Step 3
	encapsulation encapsulation-type	Sets the BRI0 interface encapsulation type.
	Example:
	Router(config-if)# encapsulation ppp
	Router(config-if)#
Step 4
	dialer pool-member number	Specifies the dialer pool membership.
	Example:
	Router(config-if)#dialer pool-member 1
	Router(config-if)#
Step 5
	isdn switch-type switch-type	Specifies the ISDN switch type.
	Example:
	Router(config-if)# isdn switch-type
	basic-net3
	Router(config-if)#
Step 6
	exit	Enters global configuration mode.
	Example:
	Router(config-if)# exit
	Router(config)#
Step 7
	interface dialer dialer-rotary-group-number	Creates a dialer interface (numbered 0–255) and
		enters into interface configuration mode.
	Example:
	Router(config)# interface dialer 0
	Router(config-if)#

	Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
13-10	OL-6426-02