Cisco Systems OL-6426-02 Ip address negotiated, Dialer pool number, Dialer-group group-number

Chapter 13 Configuring Dial Backup and Remote Management

Configuring Dial Backup and Remote Management Through the ISDN S/T Port

	Command	Purpose
Step 8
	ip address negotiated	Specifies that the IP address for the interface is
		obtained through PPP/IPCP (IP Control Protocol)
	Example:	address negotiation. The IP address is obtained
	Router(config-if)#ip address negotiated	from the peer.
	Router(config-if)#
Step 9
	encapsulation encapsulation-type	Sets the encapsulation type to PPP for the
		interface.
	Example:
	Router(config-if)# encapsulation ppp
	Router(config-if)#
Step 10
	dialer pool number	Specifies the dialer pool to be used.
	Example:	In the example, the dialer pool 1 setting associates
		the dialer 0 interface with the BRI0 interface
	Router(config-if)# dialer pool 1	because the BRI0 dialer pool-member value is 1.
	Router(config-if)#
Step 11
	dialer string dial-string[:isdn-subaddress]	Specifies the telephone number to be dialed.
	Example:
	Router(config-if)#dialer string 384040
	Router(config-if)#
Step 12
	dialer-group group-number	Assigns the dialer interface to a dialer group
		(1–10).
	Example:
	Router(config-if)# dialer group 1
	Router(config-if)#
Step 13
	exit	Exits the dialer 0 interface configuration mode,
		and enters global configuration mode.
	Example:
	Router(config-if)# exit
	Router(config)#
Step 14
	dialer-listdialer-group protocol protocol-name	Creates a dialer list for packets of interest to be
	{permit deny list access-list-number	forwarded through the specified interface dialer
	access-group}	group.
	Example:	In the example, dialer-list 1 corresponds to
		dialer-group 1.
	Router(config)# dialer-list 1 protocol ip	For details about this command and additional
	permit
	Router(config)#	parameters that can be set, see the Cisco IOS Dial
		Technologies Command Reference.

	Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
OL-6426-02		13-11