Cisco Systems UBR7225VXR quick start Related Documentation, Identify Startup Problems

Identify Startup Problems

Startup problems are commonly caused by source power problems or a board (network processing engine or cable interface line card) that is not properly connected to the midplane. With the exception of the fan tray and network processing engine, LEDs indicate all system states in the startup sequence. By checking the state of the LEDs, you can determine when and where the system failed in the startup sequence.

1.First check that you are properly plugged into the power source. Then verify that the line cards are properly installed.

2.The system cannot operate unless the network processing engine is installed properly. Check that the NPE is properly installed in the chassis.

3.Always verify that the fans are operating.

Queued messages:

%ENVM-1-SHUTDOWN: Environmental Monitor initiated shutdown

If the above message is displayed, it indicates that the system has detected an overtemperature condition or power out-of-tolerance condition inside the chassis. The shutdown message could also indicate a faulty component or temperature sensor. Before the system shuts down, use the show environment or show environment table command to display the internal chassis environment.

Other Troubleshooting Information Websites

These websites are provided to help you find the most current troubleshooting information:

•Search the Cisco TAC assistance website, at the following URL: http://www.cisco.com/en/US/support/index.html

•Search cable products field notices at the following URL: http://www.cisco.com/public/support/tac/fn_index.html

9Related Documentation

•Cisco uBR7225VXR Universal Broadband Router Hardware Installation Guide, at the following URL: http://www.cisco.com/en/US/products/ps8474/prod_installation_guides_list.html

•Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide, at the following URL: http://www.cisco.com/en/US/products/hw/cable/ps2217/products_installation_and_configuration_guides_list.html

•Cisco IOS CMTS Cable Command Reference, at the following URL: http://www.cisco.com/en/US/products/hw/cable/ps2217/prod_command_reference_list.html

•Regulatory Compliance and Safety Information for the Cisco uBR7200 Series Universal Broadband Router, at the following URL:

http://www.cisco.com/en/US/products/ps8474/prod_installation_guides_list.html

•Network Processing Engine and Network Services Engine Installation and Configuration guide, at the following URL: http://www.cisco.com/en/US/products/ps8474/prod_installation_guides_list.html

•Cisco uBR7200-NPE-G1 Read Me First, at the following URL: http://www.cisco.com/en/US/products/ps8474/prod_installation_guides_list.html

17