Cisco Systems UCS C210 manual Rear Panel LEDs

Chapter

Table 3-2	Rear Panel LEDs
LED Name			State
Power supply fault			• Off—No AC power is present in any power supplies.
			• Green—This power supply is operating properly in main power
			mode.
			• Green, blinking—This power supply is operating properly in
			standby power mode.
			• Amber, blinking—There is no AC power present in this power
			supply.
			• Amber and Green, blinking—This power supply has reached a
			Warning over-temperature condition: 176 °F (80 °C). The power
			supply auto-recovers from this condition when the temperature is
			within specification again: 167 °F (75 °C)
			• Amber—This power supply has failed. This could be because the
			power supply has reached a Critical Shutdown over-temperature
			condition: 194 °F (90 °C). The power supply auto-recovers from
			this condition when the temperature is within specification again:
			167 °F (75 °C).
			See the “Connecting and Powering On the Server (Standalone Mode)”
			section on page 2-9for definitions of these power modes.
Locator			• Off—The Locator LED is not in use.
			• Blue, flashing—The Locator LED/button on the front panel was
			pressed and the Locator LED flashes on the front and rear panels
			to help you find the server in a rack.
	Note	The 10/100 Ethernet link status LED and the speed LED must be read in
		combination for the following interpretations.

10/100 Ethernet link status (right)

10/100 Ethernet speed (left)

•Right off + left off—No link is present on this port.

(Also indicates a connected switch port that is set to 1000 Mbps.)

•Right off + left green—Half-duplex, 10-Mbps link is present.

•Right green + left blinking green—Half-duplex, 100-Mbps link.

•Right off + left blinking green—Full-duplex, 10-Mbps link.

•Right green + left blinking green—Full-duplex, 100-Mbps link.

Cisco UCS C210 Server Installation and Service Guide

OL-20887-02 3-5