Cisco Systems Version 1.1 CSR Commands, Activating Inactive Datasets, Cleaning Test Results, page

Chapter4 CSR GUI Functionalities

CSR Commands

Figure4-38 Destroy Message in Inactive Dataset

Step 2 Click Yes to destroy the inactive dataset, or No to quit destroying.

Activating Inactive Datasets

An inactive dataset is not loaded into the CSR memory, with the exception of test commands. To place the dataset in the CSR memory for routing, use the following steps:

Step 1 In the Inactive Dataset tab in the CSR window, click Verify Dataset in the Dataset Commands area to verify the inactive dataset.

Step 2 Click the Configuration Management tab, and click Swap Active/Inactive Datasets to swap the inactive dataset to active dataset.

Step 3 In the Select Dataset box, click Load Dataset into CSR.

Step 4 Click Swap to swap the datasets, or click Cancel to cancel swapping.

Also see “Swapping Datasets” section on page4-12.

CSR Commands

This section describes how to use the CSR Commands tab in the CSR window for the following functionalities:

•Sending Test Route Request Commands to an Active CSR Application, page 4-42

•Updating Logging Level, page 4-44

•Loading the Active Dataset, page 4-44

•Resetting Call Accounting, page 4-45

•Updating Gatekeepers, page 4-45

•Cleaning Test Results, page 4-45

Cisco Carrier Sensitive Routing User Guide

4-41