Cissell CAB438C Operating Controls and Indicators, Function, Operation, Indicators, Controls or, Position or Indication

Operation

Operating Controls and Indicators

	Controls or	Function	Position or Indication
	Indicators	Function	Position or Indication
	Indicators

1.	Red stop button	Stops electrical service to blowers, timers, and heat exchanger.	Press to actuate.

2.	Cycle timer control	Determines pressing cyle time.	Rotate knob to desired
knob			setting.

3.	Steam timer control	Determines the length of sleeve steaming time. Normally set at	Rotate knob to desired
knob		5 seconds.	setting.

4.	Water gun needle	Turns water on and off to water spray gun.	Turn clockwise to turn
valve			water off. Turn
			counterclockwise to turn
			water on.

5.	Reset button	Energizes the air power control circuit. Press must be reset if press gauge	With buck in the out
		(item 6) registers 0 psi.	position, press reset
			button.

6.	Gauge, reset system	Indicates that air power is on or off to press.	When gauge shows line
			pressure, air is reset to
			press. When gauge shows
			zero pressure, air must be
			reset for press to operate.

7.	Right gray buck in	When pressed simultaneously with the left gray buck in button	Press simultaneously
button		(item 13), moves buck from dressing position to pressing position inside	with left gray buck in
		cabinet.	button (item 13) to
			actuate.

8.	Black vacuum	Turns vacuum off to buck.	Press to actuate.
release button

9.	Emergency Stop	Exhausts entire air system except for air to collar clamp air cylinder.	Press to actuate. Turn in
button		Stops buck travel and opens press heads or keeps press heads from	direction of arrow on
		closing. Press will not operate until air circuit is reset. (Applies to	button to reset. Button
		machines produced after 1997.)	will pop up after
			approximately 1/8 turn.

10. Collar clamp foot		Opens clamping arm on collar clamp (item 16).	Depress foot pedal to
pedal			open collar clamp.
			Release foot pedal to
			close collar clamp.

11. Sleeve extender/		Moves the sleeve extenders out and turns vacuum on to buck.	Depress foot pedal to
vacuum foot pedal			actuate.

12. Sleeve extender		Retracts sleeve extenders, which brings them in toward the buck. Should	Press to actuate.
release button		be actuated before dressing shirt on buck.

13. Left gray buck in		When pressed simultaneously with the right gray buck in button	Press simultaneously
button		(item 7), moves buck from dressing position to pressing position inside	with right gray buck in
		cabinet.	button (item 7) to actuate.

14. Red head release		Opens the press heads. Buck will automatically return to the dressing	Press to actuate.
button		position when heads open.

Table 1 (Continued)

AJ0975