Operation
Buck Dressing Instructions
The steps listed below outline the procedure for dressing a shirt on the buck.
1.Grasp shirt by neck band with label side facing you. Turn to buck and swing the right arm of shirt over the buck (at the same time you are guiding the left side so the buck fills shirt armhole). Refer to Figure 5.
NOTE: This action should be as natural as putting on your own shirt. Never lift the shirt over the buck (this would result in unnecessary fatigue).
4.Depress collar clamp foot pedal to open collar clamp. Slide index finger of each hand along neck band from the top down to the points of the collar. Guide left collar point under right point. Butt neck band ends together. Do NOT overlap band ends except for large size shirts. Refer to Figure 7.
5.Hold neck band ends up in place with two fingers placed just below button and buttonhole of neck band. Release collar clamp foot pedal to close clamp against shirt collar. Buttonhole must be under clamp so that button strip will not distort it when pulled. Refer to Figure 8.
CAB417N
Figure 5
2.Using your right hand, bring the shirt around the buck and let it rest in position. Grasp extreme ends of shirt yoke with both hands. Stretch yoke and center shirt on the buck. Refer to Figure 6.
3.Front seam of yoke should form a straight line across the buck when properly dressed.
CAB418N
Figure 6
CAB419N
Figure 7
CAB420N
Figure 8
14 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | AJ0975 |