Citizen CBM1000 manual GS a m n, Range

GS <

[Function]	Initializing the printer mechanism
[Code]	<1D>H<3C>H
[Outline]	Perform a label initialization identical to power-on initialization.
[Caution]	This command is valid only if "label" is chosen.
	• Parameters configured by commands are not reset.

GS A m n

[Function]	Correcting the label top position
[Code]	<1DH><41>H<m><n>
[Range]	0	m	255
	0	n	255
[Outline]	This command sets the label head position in terms of correction
	value the default position.

•m denotes the correctingdirection and valid only for the least

•significant bit(m0).

m0 Correcting direction

0Corrects in the forward direction

1 Corrects in the reverse direction

[Caution]	• This command is valid only if "label" is chosen.
	• This command is ignored immediately after the execution of a
	leader positioning command (FF, GS FF, GS A, GS <) or
	immediately after leader positioning performed on a paper
	feed action with the FEED switch, power on, or cover closure.
	• The maximum reverse correction span is 0.5 mm. Correction
	settings exceeding this value are truncated into the maximum
	value. The label may be mispositioned due to paper flexure.
	For reverse correction, exercise care so the leader position
	does not step out of the label.
	• For forward correction, set the correction span by taking into
	account the label length as the printable area changes before
	and after correction setting.
	• In calculating a correction span, use the calculated basic feed
	span for the vertical direction. The fractional part contained in
	the calculation result should be used for correction at an
	increment of the mechanism's minimum feed span, with the
	remaining fractional part truncated.
[See Also]	FF, GS FF

— 142 —