Citizen CBM1000 manual ESC $ n1 n2, Default

ESC $ n1 n2

[Function]	Specifying the absolute positions
[Code]	<1B>H<24>H<n1><n2>
[Range]	0	n1	255
	0	n2	255
[Outline]	The printing start position is specified with the number of dots
	(1/203 inch unit) from the beginning of a line.

•The number of dots is divided by 256, whose quotient is taken as “n2” and the residual as “n1”.

•Therefore, the printing start position is equal to n1 + n2 × 256 from the beginning of a line.

[Caution]	The basic calculation pitch is set by GS P. After the line feed
	width is set, if the basic calculation by GS P leaves a fraction,
	the fraction is corrected with the minimum pitch of the
	mechanism, and the remainder is omitted.
	In STANDARD MODE, this command uses the horizontal (Paper
	feed direction) basic calculation pitch (x).
	In PAGE MODE, this command acts differently depending on
	the start point:
	(1) If the start point specified by ESC T is top right or bottom
	left, the command uses the vertical (Paper feed direction)
	basic calculation pitch (y).
	(2) If the start point specified by ESC T is top left or bottom
	right , the command uses the horizontal (Perpendicular to
	the paper feed direction) basic calculation pitch (x).
	Specification beyond the end of the line is ignored.
[Default]	The initial value is not defined.
[See Also]	ESC \, GS P, GS \, GS $

— 60 —