Chapter3 Preparing the Printer
Installing Roll Paper
The following are the types of roll paper that can be used by this printer. Types: 1P roll paper
2P copy roll paper (1 original + 1 copy)
3P copy roll paper (1 original + 2 copies)
(2P and 3P copy roll paper are only usable on models equipped with auto cutter and rewinder.)
Paper widths: 76.2 (±0.7)/69.5 (±0.6)/57.5 (±0.5)mm
Roll diameter: φ30mm to φ83mm
Core diameter: Interior diameter
Paper thickness: 1P 0.06 to 0.085mm
Copy paper 0.05 to 0.20mm (total thickness)
But the total thickness that can be cut is from 0.05 to 0.14mm.
Standard and Auto Cutter Equipped Models
Installation method | Rear cover open lever |
1. Pull the rear cover open lever towards you to open the rear cover.
2. Set the attached partition in place if the roll paper you are using is 69.5mm wide or 57.5mm wide.
Change the paper width by changing the value set as the width using the Soft SW Setting Mode.
Caution
When setting the roll paper, be careful not to cut your hand on the edge of
the paper.
Partition
Location set for width of 57.5mm Location set for width of 69.5mm
28