4. After removing the rewinder shaft, install the copy roll paper and pull the end of the roll paper straight towards you for about 30cm as shown in the figure.
Hold the center of the roll paper to pull it as straight as possible so that one of the sides of the paper does not slacken.
Rewinder shaft
2P or 3P copy roll paper
About 30cm
5. Maintaining light tension in the copy roll paper, firmly close the platen unit until you hear a click.
Caution
Be very careful not to let your hands touch the blade on the paper cutter bar.
Roll paper that is gently pulled taut.
Platen unit
Be careful of the paper cut bar.
6. Set one side of the copy roll paper (copy side) on the rewinder shaft as shown in the figure, and tightly wind it about 2 rotations in the direction shown by the arrow.
Check to make sure that the copy roll paper rotates with the rewinder shaft.
Copy roll paper (copy side)
Rewinder shaft
Protrudes about 5cm
Wind it about twice
31