Chapter4 Maintenance Mode
Soft SW Setting Mode
Operating methodPress the FEED switch (less than 2 seconds): The setting changes.
The present set value is changed and the same item is reprinted. (Press the FEED switch, and when the buzzer sounds once, release it.)
Pressing the FEED switch continuously (2 seconds or more):
Moves to the next item.
It prints the present set value of the next item. (Press the FEED switch, and when the buzzer sounds three times, release it.)
Opening/closing the front cover:
After saving the set values, it reprints all items from the top and returns to normal power on status.
*If the power is turned off without opening and closing the front cover, the setting change is invalid.
*If the paper runs out during the change, set the paper and close the rear cover to continue the process.
Operations
Press the FEED Switch
Press and hold the FEED Switch
Press and hold the FEED Switch
Press the FEED Switch
Press Feed
Change PARM.
Press Feed For 2S
Next Item
F.Cover Open/Close
Save & Exit
<Soft | |
Command Type | |
Number of Col. | |
Font Select | |
Paper Plies | |
Paper End | |
Paper | |
Slashed Zero | |
Print Direct. | |
Auto LF | |
Code Page | |
Buffer Size | |
Init Signal | |
Buzzer | |
Baud Rate | |
Data Length | |
Parity Bit | |
Stop Bit | |
Protocol | |
Paper Width | |
Color Ribbon | |
Black Mark | |
Command Type | |
Command Type | |
Number of Col. | |
Font Select | |
Font Select |
Example of a change of the Command Type to STAR and the Font Select to 9⋅9.
36