Set item | Initial value | Setting value | Remarks |
|
|
|
|
ON | ON | Selects the rewinder function. | |
|
| OFF | During OFF, the rewinder motor does not operate. |
Black Mark | DIS | DIS | Selects enabled (TYPE1, TYPE2)/disabled (DIS) of the |
|
| TYPE1 | black mark control function. |
|
| TYPE2 | In TYPE1 status, auto paper length measuring operation |
|
|
| is done and the black mark is fed to the paper cut |
|
|
| position when the power is turned on. |
|
|
| GS FF/FF commands are available in the status. |
|
|
| It is used for formatting the black mark at the edge of |
|
|
| the page. |
|
|
| In TYPE2 status, measuring operation is not done when |
|
|
| the power is turned on. |
|
|
| The auto paper length paper measuring, initial paper |
|
|
| positioning and paper cutting operations are controlled |
|
|
| by the command from a host PC. |
|
|
| FS(L command only is available in the status. |
|
|
| It is used for formatting the black mark in the middle of |
|
|
| the page. (TYPE2 status is not available in STAR and |
|
|
| CBM1/2 modes.) |
|
|
|
|
Concerning
Functions that are not supported by the specifications at time of shipping have no impact on printer operation even when the settings are changed.
Examples)Items set for the
Change of the setting of the
Concerning
The minimum cutting interval is 1/2 inch (3 lines with 6LPI).
Once a cut command has been executed, even if a command is sent before the paper has fed at least 1/2 inch, the cut command is ignored so the cut action cannot be executed.
Initial Factory Shipping Mode
Setting the mode
1. Pressing the FEED switch twice in
maintenance mode (POWER LED is |
|
flashing) causes the POWER LED, PAPER |
|
OUT LED, and the ERROR LED to begin | Flashing Press twice |
to flash. |
Mode Maintenance
39