Chapter4 Maintenance Mode
Initial Factory Shipping Mode2. Reopening and closing the front cover in this status switches the POWER LED, PAPER OUT LED, and the ERROR LED from flashing to continuously lit status.
3. Pressing the FEED switch for 3 seconds or more restores settings to the factory shipping (initialized) status.
Reopening and closing the front cover: Flashing Lit
Cut Position Adjustment Mode
Setting the mode
1. Pressing the FEED switch 3 times in maintenance mode (POWER LED is flashing) causes the POWER LED and the ERROR LED to begin to flash.
Flashing | Press 3 times |
|
2. Reopening and closing the front cover in this status switches the POWER LED and the ERROR LED from flashing to continuously lit status and enters Cut Position Adjustment Mode.
Reopening and closing the front cover:
Flashing Lit
Pressing the FEED switch (less than 2 seconds):
The present value is changed in units of
±1/144.
Opening and closing the front cover: The ± of the adjustment direction changes. Immediately after entering adjustment mode, the value is changed in the + direction. Opening then closing the front cover changes the ± of the adjusted value.
Pressing and holding the FEED Switch (2 seconds or more):
The present value is saved and the printer enters normal power on status.
Cutter Amendment : +000
Cut position | Paper feed |
| direction |
Adjustment range:
Initial value: +000
40