Installation
This printer can be installed horizontally or vertically and can be wall mounted.
But according to the model you are using, there may be restrictions on how it is installed. Refer to the following table.
| Horizontal | Vertical | Wall Mount | |
Standard model (AC adapter type) | Yes | No | Yes*2 | |
Standard model | Yes | Yes*1 | Yes*2 | |
Auto cutter equipped model (AC adapter type) | Yes | No | Yes*2 | |
Auto cutter equipped model | Yes | Yes*1 | Yes*2 | |
|
|
|
| |
Auto cutter and rewinder equipped model | Yes | No | No | |
(AC adapter type) | ||||
|
|
| ||
|
|
|
| |
Auto cutter and rewinder equipped model | Yes | No | No | |
|
|
| ||
|
|
|
|
*1: Accessory rubber feet must be used to prevent slipping.
*2: The optional specialized wall mount unit is necessary to mount it on the wall.
Vertical installation and wall mounted installation
To install the printer vertically or wall mounted, remove the Chassis Platen L Spring used to open the rear cover. And reverse the LED name sheet on the operation panel to use it with the vertically installed and wall mounted display.
1. Open the rear cover. Do this carefully, because the cover snaps open vigorously.
2. Lift part A with the fingers of your right hand.
3. Switch the Chassis Platen L Spring that you have raised from your right thumb to your left thumb to hook the protrusion on the end of the Chassis Platen L Spring inside part B of the printer.
Chassis Platen
LSpring
Part A
erPrint the gPreparin
Caution
Chassis Platen L Spring with strong | Protrusion |
repulsive force is used. Be very careful |
|
that it does not slip off your finger |
|
causing an injury. | Part B |
|
Remove and reverse the sheet then reinsert the protruding part of the center of the sheet in the printer and push in both ends.
23