Chapter4 Maintenance Mode
Soft SW Setting Mode
Set item | Initial value | Setting value | Remarks |
|
|
|
|
Buffer Size | 4k | 40byte | The receiving buffer size is selected. |
|
| 4Kbyte |
|
Init Signal | ENB | ENB | Selects enabled (ENB)/disabled (DIS) of the printer |
|
| DIS | initialized signal (PRIME) during |
|
|
| Selects enabled (ENB)/disabled (DIS) of the 25pin reset |
|
|
| signal during serial interface. |
Buzzer | ON | ON | Selects buzzer sound when an abnormality occurs as |
|
| OFF | enabled (ON)/disabled (OFF). |
|
|
|
|
Set item | Initial value | Setting value | Remarks |
|
|
|
|
Baud Rate | 9600 | 19200 | Sets the baud rate of the serial interface. |
|
| 9600 |
|
|
| 4800 |
|
|
| 2400 |
|
|
| 1200 |
|
Data Length | 8 bit | 8 bit | Sets the character length of the serial interface. |
|
| 7 bit |
|
Parity Bit | NONE | NONE | Sets the communication parity of the serial interface. |
|
| EVEN |
|
|
| ODD |
|
Stop Bit | 1 bit | 1 bit | Sets the stop bit of the serial interface. |
|
| 2 bit |
|
Protocol | DTR | DTR |
|
|
|
|
Set item | Initial value | Setting value | Remarks |
|
|
|
|
Paper Width | 76.2 | 76.2 | Selects the paper size. |
|
| 69.5 |
|
|
| 57.5 |
|
PAR. | OFF | Selects the cutter operation. | |
|
| FREE | When it is OFF, the FULL/PAR. commands do not start |
|
| FULL | cutting. |
|
| PAR. | In FREE status, cutting is done according to the |
|
|
| FULL/PAR. commands. |
|
|
| In FULL status, full cut is always done by both the |
|
|
| FULL/PAR. commands. |
|
|
| In PAR status, partial cutting is always done by both the |
|
|
| FULL/PAR. commands. |
Color Ribbon | ON | ON | Selects the color function. |
|
| OFF | During OFF, the change color command is ignored. |
|
|
|
|
38