Setting Mode Table
SoftSet item | Initial value | Setting value | Remarks |
|
|
|
|
Command Type | EPSON | EPSON | The emulation is selected from EPSON/STAR/ |
|
| STAR | CBM1/CBM2. |
|
| CBM1 |
|
|
| CBM2 |
|
Number of Col. | 40/33 | 40/33 | Number of full dot in full column is 200 dots. For the |
|
| 42/35 | number of line columns based on the paper width, see |
|
|
| “Setting the Paper Width and Printing Line Column Number”. |
Font Select | 7x9 | 7Ω9 | The initial font size is selected immediately after the |
|
| 9Ω9 | power is turned on. |
|
|
|
|
Paper Plies | OFF | OFF | Copy mode is selected. |
|
| 2P | OFF/2P/3P can be selected. But when 3P is set, the |
|
| 3P | printing speed is low. |
Paper End | ENB | ENB | The PE signal enabled/disabled is set at paper end when |
|
| DIS | only the |
|
|
| enabled status, BUSY, PE, FAULT are output and printing |
|
|
| stops at paper out. During disabled status, only BUSY is |
|
|
| output and printing stops at paper out. |
|
|
|
|
Paper | ENB | ENB | The PE signal enabled/disabled is set at paper near end |
|
| DIS | when only the |
|
|
| enabled status, PE, FAULT are output and printing |
|
|
| continues. During disabled status, nothing is output and |
|
|
| printing continues. |
|
|
|
|
Slashed Zero | OFF | OFF | It sets whether or not slash is used with the numeral 0 |
|
| ON | (zero). |
Print Direct. | Designates printing direction. When | ||
|
| printing starts from the closer of the left and right ends | |
|
|
| of the next printing line from the print stop location. |
|
|
| During |
|
|
|
|
Auto LF | OFF | OFF | The LF operation during CR code reception is selected. |
|
| ON | When ON, LF does not operate; when OFF, LF operates. |
|
|
| CR: Carriage Return LF: Line Feed |
Code Page | 437 | 437, | The code page is selected. |
|
| KATAKANA, |
|
|
| 850, 860 |
|
|
| 863, 865 |
|
|
| 852, 866 |
|
|
| 857, 858 |
|
|
| WPC1252 |
|
Mode Maintenance
37