Citizen Systems iDP3240 user manual DLE ENQ, GS a, and GS r, Identification of Send Status

(3) Status caused by an error (when n = 3 is specified)

Bit	Status	Hex.	Decimal
0	Unused (Fixed at 0)	00	0
1	Unused (Fixed at 1)	02	2
2	Undefined	—	—
3	Auto cutter error not occurred	00	0
	Auto cutter error occurred	08	8
4	Unused (Fixed at 1)	10	16
5	Unrecoverable error not occurred	00	0
	Unrecoverable error occurred	20	32
6	Auto recovery error not occurred	00	0
	Auto recovery error occurred	40	64
7	Undefined (Fixed at 0)	00	0

Bit 3: If this error has occurred, remove the cause of the error, and then DLE ENQ n (1 n 2) can be used to recover from the error. However, it is not possible to recover from any error due to a damaged cutter or circuit problem (e.g., broken wire).

Bit 6: If a head overheat error is detected, the printing is stopped until the head temperature falls. At this time, bit 6 = “1”.

(4) Continuous paper detector status (When n = 4 is specified)

	Bit	Status	Hex.	Decimal
	0	Unused (Fixed at 0)	00	0
	1	Unused (Fixed at 1)	02	02
	2,3	Paper found by Paper Near-end Sensor	00	0
		Paper not found by Paper Near-end Sensor	0C	12
	4	Unused (Fixed at 1)	10	16
	5,6	Paper found by Paper-end Sensor	00	0
		Paper not found by Paper-end Sensor	60	96
	7	Unused (Fixed at 0)	00	0
[See Also]	DLE ENQ, GS a, and GS r, “IDENTIFICATION OF SEND STATUS”
	in APPENDIX 3

— 53 —