Citizen Systems iDP3240 user manual ESC $ n1 n2, Default

ESC $ n1 n2

[Function]	Specifying the absolute positions
[Code]	<1B>H<24>H<n1><n2>
[Range]	0	n1	255
	0	n2	255
[Outline]	The printing start position is moved to a position specified with
	(n1 + (n2 × 256) ) × basic calculation pitch from the beginning
	(left margin) of a line.
	• The moved position is divided by 256, whose quotient is taken
		as “n2” and the residual as “n1”.
	• Therefore, the printing start position is equal to n1 + n2 × 256
		from the beginning of a line.
[Caution]	The basic calculation pitch is set by GS P. After the line feed
	width is set, if the basic calculation by GS P leaves a fraction,
	the fraction is corrected with the minimum pitch of the
	mechanism, and the remainder is omitted.
	In STANDARD MODE, this command uses the horizontal (Paper
	feed direction) basic calculation pitch (x).
	In PAGE MODE, this command acts differently depending on
	the start point:
	(1) If the start point specified by ESC T is top right or bottom
		left, the command uses the vertical (Paper feed direction)
		basic calculation pitch (y).
	(2) If the start point specified by ESC T is top left or bottom
		right , the command uses the horizontal (Perpendicular to
		the paper feed direction) basic calculation pitch (x).
	Specification beyond the end of the line is ignored.
[Default]	The initial value is not defined.
[See Also]	ESC \, GS P, GS \, GS $

— 61 —