ClearSounds A300 manual Charging the Handset, Using the Handset Carrying Clip

4.Insert the new batteries. Be sure to observe battery polarity as imprinted on the inside of the compartment.

5.Replace the battery compartment cover by sliding upward until it clicks into place and then use the screwdriver to insert the screw.

6.Replace the memory dial reference card.

NOTE: The batteries need to be replaced if they do not recover their full storage capacity after recharging. Check the battery icon on the LCD to see the battery charge level.

When replacing the batteries, always use good quality Ni-MH AAA re-chargeable batteries.

Charging the Handset

1. Place the handset into the base. The LCD screen will light up, the Charge indicator light turns on and you will hear a beep to indicate charging has begun.

2. Important: Before initial operation, you should fully charge the handset for at least 14-16 hours.

3. After the batteries are fully charged,

check for dial tone by pressing the dial key on the handset.

When battery power is very low and you place the handset on

the base, the display will show . Check the battery icon on the LCD to see the battery charge level.

Using the Handset Carrying Clip

You may choose to use the optional belt clip provided with your handset.

1.To attach, slide the belt clip down onto the grooves. Press the tabs on the belt clip

into the slots to attach.

2.To remove, insert a screwdriver along the edge of one of its “arms” and release the clip and then lift it off.

14 – ENGLISH