ClearSounds A300 manual Desk / Table Mounting, Wall Mounting

Bottom of base

Desk / Table Mounting

1.Connect one end of the 6 ft phone cord to the line jack on the back of the base and connect the other end to a modular phone jack.

2.Plug the AC power adapter into the jack on the bottom of the base, then plug the AC adapter into a standard electrical outlet or surge protector.

NOTE: The adapter is required for the phone to work.

Wall Mounting

1. Install two self-tapping screws (not supplied) at a distance of 86.5 mm apart from each other on a horizontal line.

2.Plug the AC power adapter into the jack on the bottom of the base. NOTE: The adapter is required for the phone to work.

3.Connect one end of the 8-inch phone cord to the line jack on the bottom of the base and connect the other end to a modular phone jack.

4.Holding the base slightly above the mounting screws on the wall jack, push the base against the mounting screws so they are hooked into the left and right keyhole slots on the back of the phone. Slowly slide the base down until it snaps into place.

5.Plug the AC power adapter into the electrical outlet. CAUTION: To reduce risk of personal injury, fire, or damage use only the adapter provided.

Installing Batteries Three AAA re-chargeable Ni-MH batteries come with your phone. You must install the batteries before using your phone.

1.Remove the memory dial reference card by sliding it downwards.

2.Use the screwdriver provided to remove the screw.

3.Remove the battery compartment cover by sliding it downwards.

13 – ENGLISH