Compaq N110 manual Pull the heat sink away from the base enclosure at a

Removal and Replacement Procedures

3.Lift the front edge of the heat sink and swing it up and back until the shield rests at a 45-degree angle 1 (Figure 5-13).

4.Pull the heat sink away from the base enclosure at a

45-degree angle 2 and remove it from the base enclosure.

Figure 5–13: Removing the Heat Sink

A thermal pad 3 is installed on the heat sink and makes contact with the processor. Any time the heat sink is removed, inspect the thermal pad for damage.

5–20 Maintenance and Service Guide