4.6Access Panel

1. Prepare the computer for disassembly (Section 4.2).

WARNING: Power is continuous to the system board and power supply even when the power switch is turned off. To prevent damage to the unit, disconnect the power cord from the power source or the unit before beginning disassembly procedures.

2.Lay the computer down on its large base for greater stability.

3.Remove (440BX) or loosen (Intel 810/810e) the two screws that secure the access panel to the back of the computer chassis.

4.Slide the access panel backward approximately 1-inch (2.5-cm); then lift it up and off the unit.

Removing the Access Panel - 440BX

Removing the Access Panel - Intel 810/810e

To replace the access panel, reverse the previous steps.

Compaq Deskpro EP Series of Personal Computers

4-7

Page 50
Image 50
Compaq EP Series manual Access Panel