4.17.2Processor Guide Rails

1. Prepare the computer for disassembly (Section 4.2).

WARNING: Power is continuous to the system board and power supply even when the power switch is turned off. To prevent damage to the unit, disconnect the power cord from the power source or the unit before beginning disassembly procedures.

2.Lay the computer down on its large base for greater stability.

3.Remove the access panel (Section 4.6).

4.Remove the processor (Section 4.17.1).

5.Remove the system board from the chassis (Section 4.18).

6.Turn the system board over so the bottom side is up, then use a short, small diameter screwdriver to press the push-pins out of the plastic Tufloks that secure the processor rails to the system board.

Removing the Processor Rails

Compaq Deskpro EP Series of Personal Computers

4-37

Page 80
Image 80
Compaq EP Series manual Processor Guide Rails