Compaq EP Series manual Replacing the Processor Rails

7.With the Tuflok pins in their full up position, firmly pull on each leg of the processor rail to disengage it from the system board.

8.Place each of the type 2 processor rail goalposts (Compaq part number 350767-002) in position with the open end facing the processor socket and push firmly down to fully seat the free end of each Tuflok in its hole. Then push down on each push-pin to secure the goalpost.

Replacing the Processor Rails

!Reinstall the system board in the computer chassis.

!Use your fingernail to lift and remove the four push tabs that attach the processor guide rails to the system board, then remove the rails.

To replace the processor guide rails, seat the guide rails flush with the system board, then press in the push tabs to attach the rails to the system board.

4-38 Removal and Replacement Procedures