2.3Line Configuration
While you must share the same Line 1 telephone number at all the stations, you may choose to leave some lines unconnected at particular stations or to connect private or auxiliary lines to Lines 2, 3 or 4 at particular stations.
2.3.1COMMON
This is the factory setting for all lines. This setting assumes that the line is connected to the same telephone number at all stations.
2.3.2PRIVATE
Use this setting at any telephone that is connected to a different telephone number than the corresponding line at the other stations.
For example, you may connect your private telephone number to Line 3 at your station instead of connect- ing your station to the shared Line 3. In this example, you would set Line 3 at your station as PRIVATE.
2.3.3UNCONNECTED
Use this setting at any telephone that is not physically connected to all of its lines. For example, you may install a 2740
a.Press MENU. The display will read “Phone Setting.”
b.Press ENTER.
c.Press the DOWNARROW repeatedly until the display reads ”Line Connections.”
d.Press ENTER. The display will show the current line connection setting for Line 2.
e.Press the soft key under CHANGE repeatedly, until the desired line connection setting for Line 2 is displayed. The choices are:
i.L2: COMMON (factory setting)
ii.L2: PRIVATE
iii.L2: UNCONNECTED
f.Press the soft key under NEXT to see the current setting for Line 3, and repeat steps c, d, and e to change the settings for Lines
g.Press MENU to exit.
2.4Loop Voltage Detector
a.Press MENU.
b.Press DOWN ARROW repeatedly until “Advanced Setting” appears in the display.
c.Press ENTER.
d.Press DOWN ARROW repeatedly until “Loop Detect:” appears in the display, along with the current setting
e.Press the soft key under CHANGE repeatedly until the desired loop detect setting is displayed. The choices are:
i.Loop Detect: 48V (factory setting)
ii.Loop Detect: 24V (24 volts)
iii.Loop Detect: 12V
iv.Loop Detect: OFF
f.Press MENU to exit.
12
