Craftsman 509398, 509399 owner manual Reposition U-Clip to New Hole Location

Assembly

Installing Table Boards (44" Wide Models)

Installing Front Table

1.Position the front table and insert the front two screws. The rear screw holes in the table do not line up on any holes in the saw base.

2.Using the rear screw holes as a drill guide, drill a 5/16" hole in the saw base for each of the two rear screws.

3.Remove the front table.

Drill 5/16" Holes Through

Sheet Metal Base

Reposition U-Clip to

New Hole Location

4.The U-Clips that were used as nuts for the rear screws must be moved to the new screw location. Remove them from the saw and reinstall them on the holes you just drilled.

Reposition U-Clip to

New Hole Location

5.A 5/16" hole must be drilled in the left and right table rails. Measure 3" from the front hole and drill a second hold. This new hole will be used to mount the front table board.

Drill 5/16"

Hole

3"

6.Identify top and bottom of table: top has counterbored holes. Place table bottom side up on solid surfaces. Hammer three tee nuts into leveling holes. (These holes are not counterbored from the top.)

Screw Hole

	Mounting
Leveling Hole	Holes

Screw Hole

Tee Nut

Leveling Hole

Mounting

Holes

Front Table-Upside Down

17