Assembly

7.Stand the front table on one edge. Put a mounting screw with a washer through each of the mounting holes. Then put a rubber grommet on the bottom of each mounting screw.

8.Place the front table on the saw so that the mounting screws line up with the U-clips. The front table should extend about one inch beyond the trim caps.

9.Start the mounting screws into the U- clips using a Phillips screwdriver. Tighten the screws until the heads are just touching the table. Make sure that the table is not squeez- ing the rubber grommets.

10.Start the leveling screws into the level- ing holes using a 1/8 inch hex “L” wrench. Tighten the screws until they are flush with the table.

11.From the underside of the table attach the table rails to the table board using the two holes nearest the end of each rail.

Rubber

Grommet

Mounting

Holes

 

Mounting

Mounting

Hole

Holes

 

Front Table on Front Edge

Leveling Front Table

NOTE: The goal of this adjustment is to make the front work table flat and parallel to the radial arm. In order to do this, you will choose four points on the table. When these four points are level, the entire table should be level.

1.Loosen the three leveling screws and be sure that the five mounting screws are snug but not overtightened.

2.Raise the radial arm until the bottom of the motor is about 2-1/2 inches above the front table.

18

Page 18
Image 18
Craftsman 509399, 509398 owner manual Leveling Front Table