Assembly
16.Move the arbor shaft over the lowest point.
17.Place the handle end of the arbor wrench over this point and lower the arm until the arbor shaft is just touching the wrench. The wrench should slide back and forth with slight contact.
18.Move the arbor shaft over another point. Do not change the elevation of the arm.
19.Tighten the mounting screws and/or lev- eling screws until the handle of the arbor wrench just fits between this point and the arbor shaft. The wrench should slide back and forth with slight contact. Use a 1/8 inch hex “L” wrench to tighten the leveling screws.
20.Repeat steps
Making Front Table Flat
1.Lay the edge of the rear table across the front edge of the front table. There should be no gaps between the two.
2.If you see a gap larger than 1/32 inch, tighten the center mounting screw and/or the leveling screws until the gap is gone. Use a 1/8 inch hex “L” wrench to tighten the level- ing screws.
3.Repeat steps
20
