Assembly
7. The following items can now be removed from the front of the yoke as an assembly:
a. Shaft support |
|
| |
b. Shaft washer |
|
| |
c. Washer .505 x 7/8 x 1/16 |
|
| |
d. Bevel lock lever |
|
| |
e. Square nut 1/2 x 13 |
|
| |
f. Bevel spring wedge |
|
| |
g. Bevel lock knob |
|
| |
h. Screw, pan head plastite no. 8 x 3/8" |
| b | |
long |
| ||
| c | ||
8. Remove the bevel spring wedge from | a | d | |
e | |||
this assembly by rotating shaft support coun- |
| ||
| f | ||
terclockwise until it comes out of the square |
|
| |
nut located between the bevel lock lever and |
| h | |
the bevel spring wedge. Do not remove any |
| ||
|
| ||
other items. Remove square nut then |
| g | |
remove the bevel spring wedge from the |
| ||
bevel lock lever. |
|
|
9.Replace the bevel lock lever, with new one supplied with kit. Reinsert bevel wedge in new bevel lock lever. Reinsert square nut between bevel lock lever and bevel lock wedge. Reinsert the shaft support and rotate clockwise until end of shaft is flush with the rear of the bevel lock wedge.
NOTE: Bevel lock lever must be replaced to prevent interference with guard assembly.
10.Reinstall the shaft support assembly into the yoke.
11.Reinstall the bevel spring using the screw previously removed. Make sure the slot in the bevel spring is in the groove of the index pin before tightening.
12.Reinstall the yoke cover using the plas- tite screws previously removed or by clipping back in place.
22
