Assembly
Install Fence, Rear Tables, and Table Clamps
1.Insert fence, then spacer table, then rear table.
2.Tilt clamp forward and snap into place in opening at rear of table support.
3.Repeat steps for other table clamp.
4.Tighten thumbscrews to clamp table sec- tions in place.
(Steps 2, 3 and 4 only apply to models with 40" wide table boards.)
Install Guard
The guard is a very important safety feature. It covers a large part of the blade and helps protect against severe cuts. Always use the guard
1.Lock motor at 0° bevel (blade vertical).
2.Use one hand to lift clear plastic guard; use other hand to grasp rear of guard (below dust elbow). Position guard so riving knife faces front of saw.
3.Tilt front of guard down about 45°; place over blade; rotate guard to level position.
NOTE: Make sure notch in guard fits onto tab on motor adapter. This will prevent movement of guard about motor. Squeeze handle trigger to make sure it raises clear plastic guard. If it does not, remove and rein- stall guard, making sure that trigger mecha- nism engages pull link on guard.
4. Tighten guard clamp screw.
Front | Fence Spacer | Rear |
Table | Table | Table |
Parallel
26
