Cutting Aides

Clamp the featherboard to the front table, so that the angled edge of the featherboard is against the workpiece on the infeed side of the blade. Do not clamp the featherboard against the cut off part (out-feed side) of the workpiece. If clamped to the outfeed side, the featherboard can squeeze the kerf closed, put binding pressure on the blade, and cause kickback.

Straight Edge for Irregular Workpiece

WARNING

If you try to rip an irregular workpiece, it could bind blade and cause kick- back.

If the workpiece you want to rip does not have a straight edge, attach a straight-edged board to the workpiece:

a)place irregular side of workpiece against fence

b)put straight-edged board on top of work- piece and against fence

c)tack straight edged board to work piece.

Note: Straight-edged board must not extend beyond leading end of workpiece and should cover workpiece width only enough to pass between blade and fence.

Note: Use fence at least as high as com- bined heights of workpiece and straight- edged board.

Featherboard

This Side

47

Page 47
Image 47
Craftsman 509398, 509399 owner manual Featherboard This Side