Assembly

WARNING

Plugging in saw during assembly could result in electrical shock, or severe cuts from contact with spinning blade.

Do not plug in saw at any time during assembly.

Plug in saw only when it is to be used.

WARNING

This retro fit guard kit required addi- tional clearance behind fence. New table boards are being supplied for this reason.

Remove Sawblade and Guard

1.Tighten carriage lock knob.

2.Loosen guard clamp screw, remove guard.

3.Motor shaft has left hand threads. Hold shaft wrench and rotate arbor wrench down (clockwise).

4.Remove shaft nut, outer collar, sawblade, and inner collar. Dispose of guard but retain shaft nut, outer collar sawblade and inner collar.

Remove Original Table Boards, and Mounting Supports

NOTE: All original hardware (except for T-Nut) will be required for mounting retrofit parts.

1.Loosen the table clamps and remove the rear table, spacer table and rip fence.

Discard the rear table and spacer table. Save the fence, it will be reused.

2.Remove the 1/4-20 x 1" cup point screw from the T-Nut located in the front table. Retain this screw for future use.

3.Remove all remaining nuts, bolts, and washers and lift off front table. Discard the front table.

NOTE: On models with 44" wide front tables: Remove four screws from under side of table that secure table clamp channels to table.

Locate and save the five (5) rubber leveling grommets that are located between the table and base assembly. These will be needed to reinstall the new front table board.

4.For 40" wide table only. Remove table clamps and keep for future use. Remove nuts, bolts and washers that secure the left and right table support channels. Discard the support channels.

 

Set Screw

 

Leveling Hole

Bolt

 

Washer

Pan Head Screw

 

Washer

Mounting Holes

Lockwasher

Hex Nut

Lockwasher

Nut

Table Support

Table Support

Screws

Here

Flat Washer

Hex Head Bolt

13

Page 13
Image 13
Craftsman 509398, 509399 owner manual Remove Sawblade and Guard, Remove Original Table Boards, and Mounting Supports