Cuno 111405-1 manual To Replace the Bulb Behind the Lower Climatezone Drawer

TO REPLACE THE BULB BEHIND THE LOWER CLIMATEZONE™ DRAWER:

•Turn the power off (“O”) to the refrigerator at the Main Power switch in the upper machine compartment (see page 4).

•Unload and remove both Climate- Zone™ drawers.

•Remove the air diverter located at the rear of the fresh food compartment, on top of the upper ClimateZone™ com- partment.

•Lift up and remove the glass shelf.

•After the shelf is removed, 2 mounting screws are visible behind the upper drawer. Using a 1⁄4" hex head screw driver, remove these screws.

•Slide the upper compartment assembly forward.

•Disconnect the power cords at the plug by pushing in the tabs and gently pulling apart. Pull the assembly completely out and set aside.

•Remove the hex head screws behind the lower compartment.

•Slide the lower compartment assembly forward.

•Unscrew the bulb and replace with a new T8-40 watt bulb.

•Slide the assembly back into its original position and align the screw holes. Replace the two screws.

•Lift the upper assembly back into its original position leaving enough space to reach the power cords.To reconnect the upper assembly power cords, align the properly matching terminals and snap the power cords back together.

•Push the assembly back into its original position and align the screw holes. Replace the two screws and then replace the glass shelf. Replace the air diverter strip.

•Replace the drawers.

•Turn the power back on to the refriger- ator.

IMPORTANT:

•Do not remove the foam piece between the ClimateZone™ drawers.

LOWER FREEZER

COMPARTMENT

•Turn the power off (“O”) to the refrigerator at the Main Power switch in the upper machine compartment (see page 4).

•Remove the freezer basket or ice drawer that is located in front of the light (select models).

•Using a phillips screwdriver, remove the mounting screw on the light shield.

•Unscrew the bulb and replace with a T8-40 watt appliance bulb.

•Reinstall the light shield.

•Reinsert the freezer

basket or ice drawer.

• Turn the power back on to the refriger- ator.

ICE AND WATER

DISPENSER LIGHT

TO REPLACE:

•Turn the power off (“O”) to the refrigerator at the Main Power switch in the upper machine compartment (see page 4).

•Locate the light bulb in the dispenser area to the left of the actuator pad.

•Remove bulb.

•Replace the bulb, using a 120V, 7 watt bulb.

•Turn the power back on to the refriger- ator.

20