B E F O R E Y O U
C A L L F O R S E R V I C E
FRESH FOOD OR FREEZER DOOR DIFFICULT TO OPEN.
•Due to air flow between the compart- ments, it may be difficult to open the doors for several seconds after one of them is closed.
DISPENSER WILL NOT
DISPENSE WATER OR ICE
(SELECT MODELS).
•A water filter, or the filter bypass plug must be in place (see page 13).
•Door is open.
WILL NOT RUN.
•Power cord not plugged in.
•No power at the electrical outlet.
•Circuit breaker tripped or house fuse blown.
•Main power turned off (“O”) (see page 4).
•Touch the ON/OFF pad.
RUNS TOO LONG/
TOO FREQUENTLY.
•Today’s energy efficient refrigerators are larger and require more running time to maintain stable temperatures.
•Prolonged door openings.
•Too many door openings.
•Condenser needs cleaning (see page 19).
•The door not sealing (due to a package or a container holding door open).
•Warm room temperature.
NOISY OPERATION.
•Cabinet not level.
•Weak floor.
•See Normal Operating Sounds (page 21).
ODOR IN CABINET.
•Odor producing foods should be cov- ered or wrapped.
•Interior needs cleaning.
WARM AIR FROM MACHINE COMPARTMENT.
•Normal air flow for condenser circula- tion.
CABINET VIBRATES.
•Cabinet not level.
•Weak floor.
•Improper installation.
MOISTURE ON INSIDE
CABINET WALLS.
•Can occur during hot, humid weather with frequent or prolonged door open- ings.
•Door not closed properly.
EXCESSIVE MOISTURE IN OR
AROUND CLIMATEZONE™
DRAWERS.
•Food not wrapped properly.
•Hot, humid weather.
NO TEMPERATURE READOUT IN THE CLIMATEZONE™ DRAWER DISPLAY.
•The Normal Cold setting has been chosen.
CLIMATEZONE™ TEMPERATURE READOUT IS NOT WITHIN TARGET RANGE.
•For best results, refrigerator and freezer controls should be left at the factory settings (see page 5).
•After drawer openings, the addition of a new load or changing settings, the readout may vary.The temperature will recover in a short period of time.
REFRIGERATOR OR FREEZER COMPARTMENT TOO WARM.
•Refrigerator or freezer temperature set too warm.
•Prolonged door openings.
REFRIGERATOR COMPARTMENT TOO COLD.
• Refrigerator temperature set too cold.
FREEZER NOT FREEZING PROPERLY.
•Products with high sugar content may not harden completely when frozen (ice cream, concentrated juice, etc.) Do not store in door.
•Adjust freezer temperature to a colder setting.
ICE CUBES EVAPORATE.
•Cold air moving over the ice cubes causes shrinkage, especially with limited usage. This is normal.
AUTOMATIC ICE MAKER NOT OPERATING.
•Wire lever arm in up (OFF) position.
•Water supply turned off.
•Water pressure too low.
•Freezer too warm.
•Install filter or filter bypass.
FRONT CABINET SURFACE WARM TO THE TOUCH.
•Special design to limit condensation during periods of high humidity.
ICE DISPENSER NOT
OPERATING.
•Ice jam in the dispenser.
•Icemaker not operating.
•Lock switch on (see page 12).
WATER DISPENSER NOT OPERATING.
•Water supply turned off.
•Water pressure too low.
•Lock switch on (see page 12).
•Install filter or filter bypass.
23
