D-Link DSL-564T manual Information you will need about your LAN or computer

DSL-564T DSL Router User’s Guide

Information you will need about your LAN or computer:

	If your computer has an Ethernet NIC, you can connect the	Record info here
Ethernet NIC	DSL-564T to this Ethernet port using an Ethernet cable.
	You can also use the Ethernet port on the DSL-564T to
	connect to other Ethernet devices, such as a Wireless
	Access Point.
	Your DSL-564T ADSL Modem is configured, by default, to
	be a DHCP server. This means that it can assign an IP
	address, subnet mask, and a default gateway address to
DHCP Client status	computers on your LAN. The default range of IP addresses
	the DSL-564T will assign are from 192.168.1.2 to
	192.168.1.254. Your computer (or computers) needs to be
	configured to Obtain an IP address automatically (that is,
	they need to be configured as DHCP clients.)

It is recommended that your collect and record this information here, or in some other secure place, in case you have to re-configure your ADSL connection in the future.

Once you have the above information, you are ready to setup and configure your DSL-564T ADSL Router.

	The Modem may be reset to its factory default settings by performing a Restore settings
	operation within the management interface (see System Commands). If you cannot
	gain access to the management interface, you may opt to use the Reset button on the
Note
	rear panel of the device).

xii