Danby SPAC8499 manual Heater Operating Instructions, Red Light Heat Mode

Heater Operating Instructions

1)Press the MODE key until the word Heat is displayed in the LCD window. Fig. 20. Each depression of the MODE key will advance to a different mode setting (Cool-Dry-Heat-Fan). The red indicator light will come on indicating the “Heating” mode is operational (there may be a slight delay of 5-10 seconds before the cycle begins, this is normal).

2)Press the appropriateor key

to select a suitable temperature between 17°C (63°F) to 30°C (88°F). Fig. 21.

3)Press the FAN key to select the desired fan speed setting (High-Low).Your selection will be displayed in the LCD window. Each depression of the fan key will alternate between the different fan speed settings. Fig. 22.

4)Press the SWING key to activate the automatic air swing (oscillating) feature, (the “air swing” symbol will appear in the LCD window). Fig. 23. To deactivate the air swing feature, press the SWING key again.

5)To adjust “air flow” direction, (up / down only) adjust any one of the Horizontal Louver Blades (excluding the top or bottom louver) and the remaining louvers will automatically adjust to the same position. Fig. 24.

Heating stops automatically when the room temperature reaches the desired setting. The “red” indicator mode light will close. Heating will resume when the room temperature falls below the established temperature setting.

	TIMER ON		12:00	I/O	MODE
Water Full	MODE	HEAT		FAN	ON
	FAN SPEED	HIGH
				SWING	TIMER
			00
Cool/Heat/Dry		TEMP.			OFF
Red Light		Heat Mode

Fig. 20

TIMER	ON	12:00		I/O	MODE
						TEMP./CLOCK
MODE		HEAT				ADJ.
				FAN	ON
FAN SPEED HIGH
					TIMER
		TEMP.	25¡c
				SWING	OFF	CLOCK
	Temperature
						Fig. 21
TIMER	ON		12:00	I/O	MODE
						TEMP./CLOCK
MODE		HEAT				ADJ.
				FAN	ON
FAN SPEED		HIGH
					TIMER
			25¡c
		TEMP.		SWING	OFF	CLOCK

Fan Speed

Fig. 22

TIMER	ON		12:00	I/O	MODE
						TEMP./CLOCK
MODE		HEAT				ADJ.
				FAN	ON
FAN SPEED		HIGH
					TIMER
			25¡c
SWING		TEMP.		SWING	OFF	CLOCK
Air Swing						Fig. 23

Fig. 24

13