Danby SPAC8499 Remote Control Features, Upper Control Buttons, Batteries should be replaced when

Remote Control Features

The hand held remote unit allows you to control all operational aspects (excluding Auto-Timed Programs) of your Portable 4 Season Home Comfort Appliance from the convenience of your favorite armchair. Here are some things you should know about operating the unit with the hand held remote.

Upper Control Buttons

I/O: Power switch (On/Off).

Mode: Selects the operating mode (Auto–Cool–Dry/Dehumidifier–Heat–Fan).

The "auto" mode is a built in feature activated from the hand held remote unit only. Under "auto" mode, your unit will automatically select the required operating mode based on temperature selection. Dehumidifying mode is not operational under the “auto” mode function.The main unit will respond automatically, switching appropriately between modes "cool-heat-fan" to maintain the selected temperature.

Fan: Selects fan speed settings (Auto–LOW-MED-HIGH).

MODE

I/O TEMP/TIMER

FAN

SWING SET

CLOCK

L R

MODE

I/O TEMP/TIMER

FAN

SWING SET

CLOCK

L R

NOTE: The “Auto” fan speed setting is equivalent to “Medium” fan speed.

Used to adjust (increase) both time of day clock settings and temperature settings.

(1 min. increments) for time of day clock settings. (1° increments) on the Celsius scale.

(2° increments) on the Fahrenheit scale.

TEMP/TIMER

Used to adjust (decrease) both time of day clock settings and temperature settings.

(1 min. increments) for time of day clock settings. (1° increments) on the Celsius scale.

(2° increments) on the Farenheight scale.

Lower Control Buttons

(Under Lower Sliding Cover)

Swing: Used to activate automatic air swing (oscillating) feature (70° swing).

Set: Used to lock/register time of day setting.

Clock: Used to initiate time of day clock setting.

L:(Lock) Used to lock a selected program mode (Against accidental program change).

R:(Re-set) Used to cancel/reset locked programs. (Clock setting will also be erased)

˚C/˚F: Used to select temperature settings in either “Celsius” or “Farenheight”.

To operate the remote, you will require two “AAA” Alkaline batteries (included).

Batteries should be replaced when:

a)No signal (beep) is heard while attempting to program the main unit.

b)No symbol “ ” appears in the remote LCD window when a command is initiated.

Battery replacement:

1.Slide the lower control cover on the remote down until it stops. Continue pulling (gently) until the lower section separates completely from the unit.

2.Insert batteries (AAA) as depicted inside the battery chamber.(+/-)

3.Re-install lower cover.

4.If the remote control is not being used for extended periods of time (vacations etc.), batteries should be removed.

The remote operates within a range of 7 meters

(23 ft.) from the receiver located inside the main unit. Any obstruction between the receiver and remote may cause signal interference, limiting the ability to program the main unit.

NOTE: The illuminated control panel feature on the main unit is not operational when setting functions using the remote control unit. (this is normal)

19